Beta available now — a 30-day free trial with every add-on included. No card, no account. Start your free trial →
Sheet.Developments

Home / Add-ons / Nesting and CNC

Add-on Testers wanted

The job onto your sheets. The program for your table.

The job is handed over one material at a time. Its parts are nested onto your sheets, plate and offcuts, the leads go in the scrap, and the program is written for your table through a post you can read and edit.

The nesting page: a plant room's fittings auto-nested on a 1500 by 3000 sheet of 0.8 mm galv, reducers, square to rounds, a D lateral's wrap, raked spigots, a bend gore and flange ring quarters, 34 parts with 71.1% of the sheet used, and the controls for moving parts by hand
1500 × 3000sheet of 0.8 mm galv 34parts placed 71.1%of the sheet used

A plant room's fittings, every one developed in Sheet.Developments and auto-nested as they came: four reducers, two square to rounds, a D lateral's wrap, two raked spigots and a bend gore, with 24 flange ring quarters in the gaps. Nothing moved by hand; the rest of the job went onto two more sheets.

What it does

From the cut list to the table.

Auto-nest

True-shape nesting: parts fitted by their outlines, not their boxes, with rotations tried and as many sheets as the job takes.

Your stock and offcuts

The sheets and plate you hold, and the offcuts left from the last job, kept as stock to nest onto next time.

By hand, too

Drag, nudge, push a part until it touches, rotate, mirror and lock it, then auto-nest whatever is left round it.

Kerf and leads

Spacing from the kerf. Every pierce goes in the scrap, outside a profile and inside a hole, and every lead is checked so it cannot cut into a neighbour.

The program, through your post

Starter posts for generic RS-274, Hypertherm EDGE, Burny and Messer controllers, written out as plain templates you can read and change.

Checked before it runs

The program drawn back from its own G-code, so what goes to the table is what you looked at.

Gang torches

On a multi-torch table, the parts that genuinely line up at the torch pitch are cut together. Anything that doesn't is said plainly, not guessed.

A report per sheet

Each sheet drawn with its parts named, the utilisation, the cut length and pierces, and the time and cost estimated from your machine.

DXF on layers

The nested sheet as a DXF: cut, bend, seam, guide and hole lines each on a layer of its own, for a CAM program you already use.

Duct board as well

Board panels, nested and shown as the router cuts them.

Duct board is nested in the program itself, with no add-on needed: the panels, grooves and closures from your board's own library laid onto the board's sheets, and shown in 3D as the router will cut them.

Duct board panels nested on three board sheets and shown in 3D

Duct board. Return air ducts nested on three sheets of board, in 3D.

Looking for testers

Nesting on a real table

A cutting program that is subtly wrong is a far more expensive mistake than a drawing that is. Before calling the nesting finished, I want it through real jobs on real tables.

If you run a plasma or laser table and would put it through a real job on a machine you can afford to babysit, I would like to hear from you.

Get in touch about testing it

In the beta now

Nest your next job free.

Nesting and CNC output is in the 30-day trial, with every other add-on.