Beta available now — a 30-day free trial with every add-on included. No card, no account. Start your free trial →
Sheet.Developments

Home / Add-ons / Vessel calculations

Add-on

The vessel's sums, with the working shown.

Set up your own design specs, then work out the shell and head thickness from pressure and check a nozzle's reinforcement by area replacement. Every formula is shown with its numbers, and the calculation sheet prints ready for whoever signs the design.

The vessel calculations page: design specs on the left, the opening reinforcement inputs and the areas A1 to A5 against the area required on the right
934 mm²required 1926 mm²available 200 NBin a 1600 shell, 440 pad

A 200 NB inlet in a 1600 shell with a 440 pad, checked by area replacement against the design spec's numbers. Every area is listed, and the verdict says it needs the sign-off of whoever is responsible for the design.

What it does

The checks a plate shop is asked for.

Your own design specs

The design pressure and temperature, the material's allowable stress, the joint efficiency and the corrosion allowance, kept as a spec and picked for each vessel.

Shell and head thickness

From internal pressure, with the plate's under-tolerance and the thinning in forming a head allowed for.

Nozzle reinforcement

Area replacement: the area the opening takes out against what the shell, the nozzle, the pad and the welds put back.

Calculation sheets

The design basis, the geometry, every formula with its numbers, and a block for calculated, checked and approved.

It shows the working; it does not sign it. The numbers come from the spec you set up, and a design still needs the approval of the person responsible for it.

And in the program itself

Then the plate is developed and cut.

The parts of the vessel are developed in the program with no add-on: shells split to fit the plate, heads in straight or spiral petals round a crown, compensation plates curved to the shell, roll lines and pre-bend flats, weld prep on its own layer, and the heat number from the plate on every label.

A shell course split into two plates to fit a 3000 by 1500 sheet, with a single V weld prep on every edge

Split to fit. A 1600 shell course split into two plates for 3000 × 1500 stock, with a single V on every edge.

A compensation plate curved to a 1600 shell, with its nozzle hole and telltale

A compensation plate. 440 across, curved to the shell, with its hole the same cut as the shell's and a tapped telltale.

An 1800 ellipsoidal head in eight petals round a 450 crown cap, each seam turning through 30 degrees out to the rim

Spiral gores. An 1800 ellipsoidal head in eight petals round a 450 crown cap, each seam turned through 30° out to the rim, right hand. Or a constant angle to every meridian.

One spiral petal of that head developed flat, 749 by 1068 mm, its two welded edges the same length

One petal, developed. 749 × 1068 in 6 mm plate. The girth closes at every parallel and the two welded edges match; the form shows the press's share, ±14% here.

In the beta now

Check your next vessel free.

Vessel calculations are in the 30-day trial, with every other add-on.